Close
You have no items in your shopping cart.
Search

Jeep Tire Rod And Drag Link Kit Chromoly w/.750 Bolts 76-Pres Jeep TJ, LJ, JK, JKU, YJ, CJ Steel Bare GenRight

Manufacturer: GenRight, Off Road
SKU: STK-8750-GEN
$849.99
Jeep Tire Rod And Drag Link Kit Chromoly w/.750 Bolts 76-Pres Jeep TJ, LJ, JK, JKU, YJ, CJ Steel Bare GenRight
+ -

This is the GenRight Builders steering (Drag Link and Tie Rod) kit. It is a perfect Compliment to our Front 3 Link suspension kit and can be cut to fit any vehicle (including a Jeep JK, TJ, LJ, CJ or YJ) or axle width and works best with hi-steer type knuckles, commonly found on Dana 60 axles. This kit is made up of the best Component parts you can buy for on-road OR off-road use! This Heavy Duty kit Will hold up to Big tires and off-road abuse. Got a hydraulic ram? It Will work with that too.Our kit Includes: (1) Thick wall 1.375 inch diameter Heat Treated CrMoly Tubing for the tie rod (1) Thick wall 1.375 inch diameter DOM Tubing for the drag link (4) Heavy Duty 7/8 inch diameter threaded shank FK CrMoly Heim rod ends with mis-alignment spacers (4) 7/8 inch Jam nuts (4) Left and Right hand threaded tube inserts (for easy adjustment) (8) CNC Machined stainless steel safety washers (for the top and bottom of each rod end) (4) Heavy Duty 3/4 inch Grade 8 mounting hardware Why Heim rod ends? We prefer the heims over the standard or heavy duty tapered style tie rod ends because, we have seen the taper on the tie rod end Split too many steel knuckles! This is the exact same steering set up we have used on our GenRight rigs for years, and it works great Unpainted Finish Sold As A Kit Important Notes: Cutting and Welding is required: This kit requires cutting the tubing to length (tailoring it to your specific vehicle) and welding the threaded inserts onto the end of the Drag Link and Tie Rod This kit May also require pressing out the ball joints to Remove them from the stock knuckles, so you'll need a ball joint press if you are a do-it-yourselfer Do noot forget our Twisted Pitman Arm! (STK-2502) to make sure you get the Full range of motion from your steering system This kit is offered in (2) sizes 3/4 inch for Dana 60 axle knuckles and 5/8 inch for Dana 44 and 30 knuckles. If necessary please order the smaller 5/8 inch GenRight CrMo Hi-Steer Kit (STK-8625) To install this GenRight CrMo Hi-Steer Kit it Will require drilling the taper out of the knuckle with a 3/4 inch diameter drill Make it double shear with our STK-5755 bolt kit This kit requires moving the axle side trac bar mounting location to match the New higher drag link position Once Installed, you Must cycle the front suspension and steering (in all possible direction combinations) to make sure the ball joints or heims Do noot exceed their range of motion which would damage the steering Components and could cause a failure resulting in a loss of steering control

Write your own review Close Review Form
  • Only registered users can write reviews
*
*
Bad
Excellent
*
*
*
*